View: 890|Reply: 3

X Arm

[Copy Link]

1

Threads

2

Posts

13

Credits

new member

Rank: 1

Credits
13
Posted at 2018-2-19 09:49:13 | All floors |Read mode
Hey guys, Just finished assembling my X Arm. Then I did someting wrong with the "test servo" page and now all the servos are running at the same time and I dont know how to reset it. Any ideas?
Reply

Use props Report

0

Threads

1

Posts

8

Credits

new member

Rank: 1

Credits
8
Posted at 2018-2-20 14:03:49 | All floors
Last edited by bobn2tech In 2018-2-20 14:33 Editor

I tried the test servo page with ID 1 and ID 2, but it says it fails to read.  Sounds like all your servos got assigned to the same ID.  I know you can re-program the ID numbers, but I can't recall where I saw it. The bus linker board is used to assign the IDs.
Reply

Use props Report

1

Threads

2

Posts

13

Credits

new member

Rank: 1

Credits
13
 Author| Posted at 2018-2-21 09:26:31 | All floors
bobn2tech Posted at 2018-2-20 14:03
I tried the test servo page with ID 1 and ID 2, but it says it fails to read.  Sounds like all your  ...

I fixed it using the Buslinker. I had to plug 1 servo in at a time and apply the ID#.
Reply

Use props Report

24

Threads

56

Posts

402

Credits

administrator

Rank: 9Rank: 9Rank: 9

Credits
402
Posted at 2018-6-19 17:13:17 | All floors
The issue is due to the servo control board is connected with all the servos during adjustment.
First , you should make sure that the servo control board is connected with only one servo. Then, click “Apply” icon to test servo again.
Finally, if you want to know more information please click the following link: http://www.lewansoul.com/product/detail-135.html
to get xArm user manual--5 Control methods and Programming.
Reply

Use props Report

Quick Reply Back to top Back to list